Where to connect the fiber optic cable to the router

The fiber optic cable should be connected to an Optical Network Terminal (ONT), which then connects to your router via an Ethernet cable.

Step-by-

Step Connection1. Connect the Fiber to the ONT The fiber optic cable from your ISP enters your home and terminates at the ONT, a device provided by your internet service provider.

The ON

T converts the light signals from the fiber into electrical signals that your router can use. Plug the fiber cable into the ONT's designated optical port, ensuring the connector is clean and properly aligned to avoid signal loss. 2.

Link the ON

T to the Router Use a high-quality Ethernet cable (Cat6 or higher) to connect the ONT's Ethernet or LAN port to the WAN/Internet port on your router. This port is usually labeled and may be colored differently to distinguish it from LAN ports. 3.

Power Up the Devices First, plug in and power on the ONT. Wait for the status lights to stabilize, indicating a successful connection to your ISP. Then, power on your router and check that its indicator lights confirm an active internet connection.

4. Optional: Router Configuration Access your router's configuration interface via a web browser (commonly 192. 168.

0. 1 or 192. 168.

1. 1) to verify settings. For optimal performance, enable features like Quality of Service (QoS) if you use VoIP or video streaming.

Key Considerations

Do not plug the fiber directly into a standard router, as it cannot interpret optical signals.

Keep the ON

T and router in a dry, ventilated area near power outlets. Surge protection is recommended. Handle fiber connectors carefully; dirt or damage can degrade signal quality.

In some setups, the ONT and router may be combined into a single device, simplifying the connection. By following this setup, your fiber internet connection will be properly converted and delivered to your router, ensuring high-speed and reliable network performance throughout your home.