Connection from OLT to the beam splitter

To connect an OLT to a beam splitter, use a single-mode fiber from the OLT PON port to the splitter input, ensuring the splitter type and ratio match your network design.

Step-by-

Step Connection1.

Identify the OLT PO

N Port: Locate the PON port on your OLT (e.g., GPON or XGS-PON) that will serve the downstream ONTs. Each port typically supports one fiber connection to a splitter. 2.

Choose the Appropriate Beam Splitter: Select a PLC (Planar Lightwave Circuit) or FBT (Fused Biconical Taper) splitter based on your network needs.

PL

C splitters are preferred for high port counts (1: 32, 1: 64) and centralized splitting, while FBT splitters are suitable for smaller deployments. Decide on the splitting ratio according to the number of ONTs to serve and the optical budget. 3.

Connect the Fiber from OLT to Splitter Input: Use a single-mode fiber patch cord to connect the OLT PON port to the input port of the splitter. Ensure proper fiber connectors (typically SC/APC) and maintain clean, dust-free connections to minimize loss. 4.

Connect Splitter Outputs to ON

Ts: Each output port of the splitter is connected to an ONT or ONU via single-mode fiber. In a primary splitting setup, the splitter is placed near the OLT, and outputs go directly to ONTs. In a secondary (cascaded) splitting setup, the first-stage splitter connects to a second-stage splitter closer to the subscriber, then to ONTs.

5. Verify Optical Power Budget: Each split reduces optical power. For example, a 1: 4 splitter reduces power by approximately 6 dB, and a 1: 32 splitter reduces it by about 15 dB.

Ensure the OL

T output and ONT receiver sensitivity accommodate the splitter loss. 6. Test the Connection: After connecting, use an optical power meter or OTDR to verify signal strength and continuity from the OLT through the splitter to each ONT.

Confirm that all ONTs are reachable and receiving adequate signal.

Additional Considerations

Centralized vs. Distributed Splitting: Centralized splitting uses a high-ratio splitter at the central office, while distributed splitting uses smaller splitters in the field. Choose based on network density and maintenance preferences.

Connector Type and Polarity: Maintain consistent connector types (SC/APC recommended) and correct fiber polarity to avoid signal issues. Environmental Protection: Outdoor splitters should be housed in weatherproof enclosures to protect fibers from damage and moisture. By following these steps, the OLT can be effectively connected to a beam splitter, ensuring proper signal distribution to all downstream ONTs while maintaining network performance and reliability.